Lora's get stuck in wan 2.2 with kijai nodes ?
I have made a workflow with a 5 part rendering (5 x 5 second clips), with each part different prompt and lora's etc., but if I run the whole workflow a second time, I can clearly see that a lora that I previously used only in the last part is still active in the model and effecting the results in the first part. I have tried clean vram and clean cache nodes on every step but that doesn't seem to solve the problem. Restarting comfyUI does.
I'm not sure yet if within the workflow (first run) if on the second part, the lora's from the first part are still active...
Anyone experienced this same problem? is it a problem with the kijai nodes or comfyUI in general?
I thought i was going crazy....I have noticed similar behavior.
Saw the same with my looping x 5 workflow while trying to rerun, but it doesn't always happen. But there are also switch nodes/for loop from Easy-Use and others from other custom node packs, can't just point the finger at WVW.